If you like this type, come to visit us:http://stores.shop.ebay.com/powermcuelectronics.It's very cheap,dear all! So come on!
STM32F103VET6(development board ) with MP3,Ethernet,USB Host+3.2"TFT
● CPU:STMicroelectronics High-density performance line ARM-based 32-bit MCU with 512k Flash,48k RAM (on chip 12Bit A/D、D/A、PWM、CAN、USB、SDIO、FSMC……).
■ ARM Cortex-M3 running at up to 72 MHz
■ Thumb-2 instruction set
■ 72 MHz maximum frequency,1.25 DMIPS/MHz (Dhrystone 2.1)performance at 0 wait state memoryaccess
■ Single-cycle multiplication and hardware division
● support a 3.2" TFT Color LCD module, 240*RGB*320 pixels 262k color,with Touch Panel.
■support 8-bit/16-bit parallel bus interface IO controll mode
■TSC2046 touch panel controller onboard directly compatible with TSC2046 on TFT Color LCD module
■Support a SD card interface(SPI mode)
■Support a ATMEL DataFlash AT45DBxxx series device(default)
● 128M NAND FLASH on board, IO controll mode, can replacing more by youself, for example: 1Gb 2Gb 4Gb and so on.
● VS1003B MP3 decoder device on board.VS1003 is a single-chip MP3/WMA/MIDI audio decoder and ADPCM encoder. It contains a highperformance,proprietary low-power DSP processorcore VS DSP4, working data memory, 5 KiB instruction RAM and 0.5 KiB data RAM for user applications, serial control and input data interfaces,4 general purpose I/O pins, an UART, as well as a high-quality variable-sample-rate mono ADC and stereo DAC, followed by an earphone amplifier and a common buffer.
● a USB host interface,driver IC is CH376.CH376 is file manage and controll IC. Application for MCU read USB disk or SD Card file system.CH376 support USB device and USB host mode, integration USB communications protocol firmware, integration Mass-Storage device protocol firmware,integration FAT12 FAT16 FAT32 file manage system, support any USB Storage device(include U disk,USB hard disk,SD Card……).
■ support 1.5Mbps Low Speed and 12Mbps Full Speed USB, compatible USB 2.0
■ support USB-host interface and USB-device interface, support dynamic switch USB-host and USB-device mode
■ support USB device Control Transfers、Interrupt Transfers、Bulk Transfers
● A MicroChip ENC28J60 10Mbit Ethernet controller IC, IEEE 802.3 compatible Ethernet controller,Integrated MAC and 10BASE-T PHY ,Supports one 10BASE-T port with automatic polarity detection and correction,Supports Full and Half-Duplex modes ,on-board RJ45 connector with build in Ethernet transformer and two status LEDs easy interface to any microcontroller via SPI.
● A USB device interface (STM32F103VCT6 inside).
● a CAN communications interface, driver IC is SN65VHD230.
● a RS485 communications interface,driver IC is SP3485.
● two RS232 interface.
● a SD Card interface (SPI conterll mode).
● a I2C interface (connect 24LC02 EEPROM).
● a SPI interface (connect AT45DB161D or M45PE16V data flash).
● one way ADC adjust input.
● two way ADC socket input.
● one way DAC socket output.
● one beep,four programmable user LED, one power show LED, one USB show LED, three programmable user key, a five direction jockey, one RESET key.
● support 5V Power Supply and USB Power Supply input.
● All IO port all the leads, user-friendly expansion of functionality, secondary development.
● Dimensions: 15cm x 11cm.
Package included:
1X STM32F103VET6 Board
1x 3.2" LCD with Touch Panel
1x USB Cable
1x serial Cable
1x Cross Network Cable
1x 5V1A power adapter
1x CD ROM(content software,schematic,routines,drives,documents some in chinese)
Attention:
You can choice ULINK 2 Emulator(30$) or JLINK V8 Emulator(20$) for programming!You can make the "Buy It Now",and leave a message to us(what you need to add).And then we change the price for you,so that you can make the payment.
Or you give us your Paypal account,and we send the invoice to you.
Shipping & Handling
All goods shipping use the Hongkong Post or China Post Air Mail(Free shipping to all over the world).
Please allow 10-20 days (depends on where you are) for delivery (from the date of dispatch, not from the date when item ends), because all item will be shipped from our warehouse in Asia (China) via Air Mail.
The item will be posted to you within 3 working day after the payment is cleared on seller's side.
Seller will be NOT held responsibility for any lost or damage for posting items.
All the fee & tax in oversea must be paid by buyer.
If you choice EMS/FedEx/UPS/DHL/TNT,please confirm with us!
Returns Accepted
If you would like to return for other reasons, you may return most new, undamaged items within 2 weeks of delivery for goods price refund (shipping rates not return). You pay the return shipping costs.
Payment Method Accepted
PayPal:humaowang@yahoo.com.cn
Contract us
E-mail:humaowang@yahoo.com.cn
MSN:humaowang@hotmail.com
Skype Account:samuelhu
Phone: +86-013392888981
More choice!please enter our shop:
http://stores.shop.ebay.com/powermcuelectronics
Attachment:????????.zip (1008 bytes | downloaded 11 times)
STM32F103VET6(development board ) with MP3,Ethernet,USB Host+3.2"TFT
● CPU:STMicroelectronics High-density performance line ARM-based 32-bit MCU with 512k Flash,48k RAM (on chip 12Bit A/D、D/A、PWM、CAN、USB、SDIO、FSMC……).
■ ARM Cortex-M3 running at up to 72 MHz
■ Thumb-2 instruction set
■ 72 MHz maximum frequency,1.25 DMIPS/MHz (Dhrystone 2.1)performance at 0 wait state memoryaccess
■ Single-cycle multiplication and hardware division
● support a 3.2" TFT Color LCD module, 240*RGB*320 pixels 262k color,with Touch Panel.
■support 8-bit/16-bit parallel bus interface IO controll mode
■TSC2046 touch panel controller onboard directly compatible with TSC2046 on TFT Color LCD module
■Support a SD card interface(SPI mode)
■Support a ATMEL DataFlash AT45DBxxx series device(default)
● 128M NAND FLASH on board, IO controll mode, can replacing more by youself, for example: 1Gb 2Gb 4Gb and so on.
● VS1003B MP3 decoder device on board.VS1003 is a single-chip MP3/WMA/MIDI audio decoder and ADPCM encoder. It contains a highperformance,proprietary low-power DSP processorcore VS DSP4, working data memory, 5 KiB instruction RAM and 0.5 KiB data RAM for user applications, serial control and input data interfaces,4 general purpose I/O pins, an UART, as well as a high-quality variable-sample-rate mono ADC and stereo DAC, followed by an earphone amplifier and a common buffer.
● a USB host interface,driver IC is CH376.CH376 is file manage and controll IC. Application for MCU read USB disk or SD Card file system.CH376 support USB device and USB host mode, integration USB communications protocol firmware, integration Mass-Storage device protocol firmware,integration FAT12 FAT16 FAT32 file manage system, support any USB Storage device(include U disk,USB hard disk,SD Card……).
■ support 1.5Mbps Low Speed and 12Mbps Full Speed USB, compatible USB 2.0
■ support USB-host interface and USB-device interface, support dynamic switch USB-host and USB-device mode
■ support USB device Control Transfers、Interrupt Transfers、Bulk Transfers
● A MicroChip ENC28J60 10Mbit Ethernet controller IC, IEEE 802.3 compatible Ethernet controller,Integrated MAC and 10BASE-T PHY ,Supports one 10BASE-T port with automatic polarity detection and correction,Supports Full and Half-Duplex modes ,on-board RJ45 connector with build in Ethernet transformer and two status LEDs easy interface to any microcontroller via SPI.
● A USB device interface (STM32F103VCT6 inside).
● a CAN communications interface, driver IC is SN65VHD230.
● a RS485 communications interface,driver IC is SP3485.
● two RS232 interface.
● a SD Card interface (SPI conterll mode).
● a I2C interface (connect 24LC02 EEPROM).
● a SPI interface (connect AT45DB161D or M45PE16V data flash).
● one way ADC adjust input.
● two way ADC socket input.
● one way DAC socket output.
● one beep,four programmable user LED, one power show LED, one USB show LED, three programmable user key, a five direction jockey, one RESET key.
● support 5V Power Supply and USB Power Supply input.
● All IO port all the leads, user-friendly expansion of functionality, secondary development.
● Dimensions: 15cm x 11cm.
Package included:
1X STM32F103VET6 Board
1x 3.2" LCD with Touch Panel
1x USB Cable
1x serial Cable
1x Cross Network Cable
1x 5V1A power adapter
1x CD ROM(content software,schematic,routines,drives,documents some in chinese)
Attention:
You can choice ULINK 2 Emulator(30$) or JLINK V8 Emulator(20$) for programming!You can make the "Buy It Now",and leave a message to us(what you need to add).And then we change the price for you,so that you can make the payment.
Or you give us your Paypal account,and we send the invoice to you.
Shipping & Handling
All goods shipping use the Hongkong Post or China Post Air Mail(Free shipping to all over the world).
Please allow 10-20 days (depends on where you are) for delivery (from the date of dispatch, not from the date when item ends), because all item will be shipped from our warehouse in Asia (China) via Air Mail.
The item will be posted to you within 3 working day after the payment is cleared on seller's side.
Seller will be NOT held responsibility for any lost or damage for posting items.
All the fee & tax in oversea must be paid by buyer.
If you choice EMS/FedEx/UPS/DHL/TNT,please confirm with us!
Returns Accepted
If you would like to return for other reasons, you may return most new, undamaged items within 2 weeks of delivery for goods price refund (shipping rates not return). You pay the return shipping costs.
Payment Method Accepted
PayPal:humaowang@yahoo.com.cn
Contract us
E-mail:humaowang@yahoo.com.cn
MSN:humaowang@hotmail.com
Skype Account:samuelhu
Phone: +86-013392888981
More choice!please enter our shop:
http://stores.shop.ebay.com/powermcuelectronics
Attachment:????????.zip (1008 bytes | downloaded 11 times)